DTC Troubleshooting: P0617
DTC P0617:
 Starter Relay 1 Malfunction
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
  1. Turn the ignition switch to ON (II).
  1. Clear the DTC with the HDS.
  1. Wait 5 seconds.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0617 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at starter relay 1 (ST CUT) and the ECM.■
  1. Turn the ignition switch to LOCK (0).
  1. Replace starter relay 1 (ST CUT).
  1. Turn the ignition switch to ON (II).
  1. Reset the ECM with the HDS.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0617 indicated?
YES -
Check for poor connections or loose terminals at starter relay 1 (ST CUT) and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■