DTC Troubleshooting: P0341 (57)
DTC P0341:
 CMP Sensor A and CKP Sensor Incorrect Phase Detected
NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Test-drive at a steady speed between 30−60 km/h (19−38 mph) for 10 minutes.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0341 indicated?
YES -
Go to Step 9 .
NO -
Go to Step 5 .
  1. Do the VTC TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES -
Go to Step 6 .
NO -
Go to Step 9 .
  1. Test-drive at a steady speed between 30−60 km/h (19−38 mph) for 10 minutes.
  1. Check the VTC STATUS in the DATA LIST with the HDS.
Does it indicate ON?
YES -
Go to Step 8 .
NO -
Go to Step 6 and recheck.
  1. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS.
Does the screen indicate FAILED?
YES -
Go to Step 9 .
NO -
If the screen indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM. If the screen indicates NOT COMPLETED, go to Step 6 and recheck.
  1. Turn the ignition switch OFF.
Is the VTC oil control solenoid valve OK?
YES -
Go to Step 11 .
NO -
Is the cam chain damaged or stretched?
YES -
NO -
Go to Step 12 .
Is the timing OK?
YES -
Go to Step 13 .
NO -
Is the actuator OK?
YES -
Go to Step 14 .
NO -
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Clear the CKP pattern with the HDS.
  1. Test-drive at a steady speed between 30−60 km/h (19−38 mph) for 10 minutes.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0341 indicated?
YES -
Check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM, then go to Step 1 .
NO -
Go to Step 21 .
  1. Monitor the OBD STATUS for DTC P0341 in the DTCs MENU with the HDS.
Does the screen indicate PASSED?
YES -
Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in Step 20 , go to the indicated DTC's troubleshooting.■
NO -
If the screen indicates FAILED, check for poor connections or loose terminals at the VTC oil control solenoid valve and the ECM, then go to Step 1 . If the screen indicates NOT COMPLETED, go to Step 19 .