Intermediate Shaft Reassembly

Exploded View
Special Tools Required
NOTE: Refer to the Exploded View as needed during this procedure.
  1. Clean the disassembled parts with solvent, and dry them with compressed air. Do not wash the rubber parts with solvent.
  1. Press the intermediate shaft bearing (A) into the bearing support (B) using the driver (C), attachment (D) and a press.
  1. Install, then seat the internal snap ring into the groove of the bearing support.
  1. Press the intermediate shaft (A) into the shaft bearing (B) using the attachment (C) and a press.
  1. Install, then seat the external snap ring (A) into the groove of the intermediate shaft (B).
  1. Install the outer seal (A) into the bearing support (B) using the oil seal driver (C) and a press.
  1. Install the set ring.