|
DTC P2552:
ISV Actuator Control Module Relay Malfunction
-
Turn the ignition switch ON (II).
-
Clear the DTC with the HDS.
-
Start the engine.
-
Turn the ignition switch OFF, and wait 1 minute.
-
Turn the ignition switch ON (II).
-
Check for Temporary DTCs or DTCs with the HDS.
|
YES
|
-
|
|
|
NO
|
-
|
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the ISV control relay, the intake shutter valve and the ECM.■
|
-
Turn the ignition switch OFF, and wait 2 minutes.
-
Disconnect connector J (10P) the under-hood fuse/relay box.
-
Disconnect ECM connector No. 2 (58P).
-
Check for continuity between ECM connector No. 2 terminal No. 43 and body ground.
|
YES
|
-
|
Repair short in the wire between the ISV control relay and ECM connector No. 2 terminal No. 43, then go to
Step 12
.
|
|
NO
|
-
|
|
-
|
Is the intake shutter valve control relay OK?
|
-
Reconnect all connectors.
-
Turn the ignition switch ON (II).
-
Reset the ECM with the HDS.
-
Check for Temporary DTCs or DTCs with the HDS.
|
YES
|
-
|
Check for poor connections or loose terminals at the under-hood fuse/relay box, the intake shutter valve, and the ECM, then go to
Step 1
.
|
|
NO
|
-
|
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
|
-
Reconnect all connectors.
-
-
Check for Temporary DTCs or DTCs with the HDS.
|
YES
|
-
|
Check for poor connections or loose terminals at the under-hood fuse/relay box, the intake shutter valve, and the ECM. If the ECM was updated,
substitute a known-good ECM,
then recheck. If the ECM was substituted, go to
Step 1
.
|
|
NO
|
-
|
If the ECM was updated, troubleshooting is complete. If the ECM was substituted,
replace the original ECM.
If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
|
|