DTC Troubleshooting: P1065 (95)
DTC P1065:
 Fuel Rail Pressure Lower Than Expected
NOTE: Before you troubleshoot, record all freeze data and review the general troubleshooting information.
  1. Before attempting troubleshooting. Check whether DTC could have been caused by insufficient fuel level.
Was fuel insufficient?
YES -
NO -
Go to Step 2 .
  1. Check the ECT in the recorded freeze data.
Could fuel have frozen due to extremely low temperature?
YES -
Check and repair the freezing point in the low pressure fuel line, then go to Step 11 .
NO -
Go to Step 3 .
  1. Turn the ignition switch OFF.
  1. Check for fuel leaks in the high pressure fuel line (at the injector, fuel pipe, etc.).
Is there any leak?
YES -
Repair the fuel leak in the high pressure fuel line, then go to Step 11 .
NO -
Go to Step 5 .
  1. Disconnect the low pressure fuel feed hose from the fuel supply pump, and receive fuel in a container.
  1. Squeeze the fuel hand primer and operate it 30 times.
Does fuel flow out?
YES -
Go to Step 7 .
NO -
  1. Clear the DTC with the HDS.
  1. Do the FUEL RAIL PRESSURE TEST in the INSPECTION MENU with the HDS.
Is the result OK?
YES -
Intermittent failure, the system is OK at this time.■
NO -
Go to Step 9 .
  1. Turn the ignition switch OFF.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P1065 indicated?
YES -
Check for poor connections or loose terminals at the FRP sensor, the fuel supply pump assembly, and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■