DTC Troubleshooting: P0047 (172)
DTC P0047:
 Turbocharger Boost Control Solenoid Circuit Shorted to Ground
NOTE: Before you troubleshoot, record all freeze data and review the general troubleshooting information.
  1. Turn the ignition switch ON (II).
  1. Clear the DTC with the HDS.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0047 indicated?
YES -
Go to Step 5 .
NO -
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the turbocharger boost control solenoid valve and the ECM.■
  1. Turn the ignition switch OFF, and wait 2 minutes.
  1. Disconnect the turbocharger boost control solenoid valve 2P connector.
  1. Disconnect ECM connector No. 1 (96P).
  1. Check for continuity between turbocharger boost control solenoid valve 2P connector terminal No. 2 and body ground.
Is there continuity?
YES -
Repair short in the wire between the turbocharger boost control solenoid valve and ECM connector No. 1 terminal No. 78, then go to Step 11 .
NO -
Go to Step 9 .
  1. At solenoid side, measure resistance between turbocharger boost control solenoid valve 2P connector terminals No. 1 and No. 2.
Is there about 10−14 Ω at 20 °C (68 °F)?
YES -
Go to Step 16 .
NO -
Go to Step 10 .
  1. Reconnect all connectors.
  1. Turn the ignition switch ON (II).
  1. Reset the ECM with the HDS.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0047 indicated?
YES -
Check for poor connections or loose terminals at the turbocharger boost control solenoid valve and the ECM, then go to Step 1 .
NO -
Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■
  1. Reconnect all connectors.
  1. Start the engine.
  1. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0047 indicated?
YES -
Check for poor connections or loose terminals at the turbocharger boost control solenoid valve and the ECM. If the ECM was updated, substitute a known-good ECM, then go to Step 18 . If the ECM was substituted, go to Step 1 .
NO -
If the ECM was updated, troubleshooting is complete. If the ECM was substituted, replace the original ECM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.■