Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.

Turn the ignition switch ON (II).

Make sure the HDS communicates within the ECM. If it doesn't, go to the DLC circuit troubleshooting.

Turn the ignition switch OFF, and wait 2 minutes.

Remove the center console.

Remove the passenger's kick panel.

Disconnect the ECM connectors (A).

Remove the bracket (B), then remove the ECM (C).

Install the parts in the reverse order of removal.

Turn the ignition switch ON (II).

NOTE: DTC P0630 ‘‘VIN Not Programmed or Mismatch'' will be stored because VIN has not been programmed into the ECM. Ignore it, and continue this procedure.

Input the VIN to the ECM with the HDS.

Select the IMMOBILIZER SYSTEM with the HDS.

Rewrite the immobilizer code with the ECM replacement procedure in the HDS; it allows you to start the engine.

Reset the ECM with the HDS.

With DPF system: Do the DPF regeneration.