Support the engine with a jack and wood block under the oil pan.

Remove the upper part of the windshield washer tube reservoir (A), over flow tube (B) and A/C line mounting bolt (C), then remove the expansion tank (D) from the bracket.

Remove the torque rod stiffener (A) and the upper torque rod (B).

Remove the brake line mounting bolt (A) and side engine mount stiffener mounting bolts (B).

Remove the ground cable (C), then remove the side engine mount upper bracket (D).

Remove the side engine mount (A) and side engine mount stiffener (B).

Install the side engine mount and the side engine mount stiffener.

Install the side engine mount upper bracket (A), then loosely tighten the new bolt and nuts (B), and loosely tighten the bolt (C).

Install the ground cable (D).

Tighten the new side engine mount stiffener mounting bolt (E), then tighten the side engine mount stiffener mounting bolts (F).

Install the brake line mounting bolt (G).

Remove the air cleaner housing assembly.

Loosen the transmission mounting bolt and nuts (A).

Raise the hoist to full height.

Remove the engine undercover.

Loosen the lower torque rod mounting bolt (A).

Lower the vehicle on the hoist.

Tighten the side engine mount upper bracket mounting bolts and nuts.

Tighten the transmission mounting bolt and nuts.

Raise the hoist to full height.

Tighten the lower torque rod mounting bolt.

Lower the vehicle on the hoist.

Install the air cleaner housing assembly.

Install the upper torque rod (A) and torque rod stiffener (B), then tighten the new torque rod stiffener mounting bolts (C).

Tighten the new upper torque rod mounting bolts in the numbered sequence shown.

Install the expansion tank (A) to the bracket, then install the upper part of the windshield washer tube reservoir (B), over flow tube (C) and A/C line mounting bolt (D).

Install the engine undercover.