Disconnect the negative cable from the battery, then disconnect the positive cable.

Remove the engine undercover.

Remove exhaust pipe A.

Remove the intake manifold bracket.

Remove the harness clamps (A).

Remove the two bolts securing the starter, then remove the starter from the engine.

Disconnect the starter cable (A) from the B terminal, then disconnect the connector (B) from the S terminal, then remove the starter.

Install the starter cable (A) and connector (B). Make sure the starter cable crimped side of the ring terminal is facing out.

Install the starter, then loosely install the upper mounting bolt (A) and lower mounting bolt (B).

Tighten the upper mounting bolt, then tighten the lower mounting bolt.

Install the harness clamps (A).

Install the intake manifold bracket.

Install exhaust pipe A. Use new gaskets (B) and new self-locking nuts (C).

Install the engine undercover.

Connect the positive cable to the battery first, then the negative cable.

Start the engine to make sure the starter works properly.

Set the clock.