Clean the areas to be sealed with wax and grease remover.

Wipe off any excess spot sealer with thinner. After the primer is sprayed, sealer will fill the area where the spot sealer was wiped off.

Make sure you can see the sealant when the sealed part is in its proper location. Refer to engine compartment, front wheelhouse, and damper housing, dashboard upper, dashboard lower, and front floor, front floor and rear floor, rear side outer panel and rear panel, rear wheelhouse, and roof panel and side sill.

When applying sealant to the engine compartment, the door opening, and the tailgate gutter, try to match the appearance of the factory sealer. Wipe off any excess sealer.

Apply sealer to any area that a replacement part will cover. Smooth the sealer with a brush if necessary.