Power Window Driver's Motor Test
Motor Test
  1. Disconnect the 6P connector (A) from the power window motor.
  1. Test the motor by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
  1. If the motor does not run or fails to run smoothly, replace it.
Pulser Test
  1. Reconnect the 6P connector to the power window motor.
  1. Check for voltage between the terminals.
    • There should be battery voltage between the No. 1 [No. 6] (+) and No. 2 [No. 5] (−) terminals when the ignition switch is ON (II).
    • Connect an analog voltmeter between the No. 4 [No. 3] (+) and No. 2 [No. 5] (−) terminals, and run the window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0−5 V).
    • Connect an analog voltmeter between the No. 5 [No. 2] (+) and No. 2 [No. 5] (−) terminals, and run the window motor at down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter should show the average voltage between 0−5 V).
    [ ]:
    RHD type

  1. If the switch test is OK, replace the power window motor.