Sunshade Control Unit (Motor) Input Test
NOTE: If the sunshade does not work in AUTO, or the auto reverse operation works frequently, do the sunshade calibration.
  1. Turn the ignition switch OFF.
  1. Disconnect the 10P connector (A) from the sunshade control unit/motor (B).
  1. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to Step 5 .
  1. With the connector still disconnected, make these input tests at the connector.
    Cavity
    Wire
    Test condition
    Test: Desired result
    Possible cause if result is not obtained
    6
    GRN
    Under all conditions
    Check for voltage to ground: There should be battery voltage.
    • Blown No. 24 (20 A) fuse in the under-dash fuse/relay box
    • An open in the wire
    2
    BLK
    Under all conditions
    Check for continuity to ground: There should be continuity.
    • Poor ground (G501)
    • An open in the wire
    3
    PNK
    Ignition switch ON (II)
    Check for voltage to ground: There should be about less than 1 V.
    • Blown No. 10 (7.5 A) fuse in the under-dash fuse/relay box
    • An open in the wire
    4
    ORN
    Ignition switch ON (II), sunshade switch in AUTO position
    Check for voltage to ground: There should be about less than 1 V.
    • Blown No. 10 (7.5 A) fuse in the under-dash fuse/relay box
    • Faulty sunshade switch
    • An open in the wire
    5
    YEL
    Ignition switch ON (II), sunshade switch in OPEN position
    Check for voltage to ground: There should be about less than 1 V.
    • Blown No. 10 (7.5 A) fuse in the under-dash fuse/relay box
    • Faulty sunshade switch
    • An open in the wire
    10
    LT GRN
    Ignition switch ON (II), sunshade switch in CLOSE position
    Check for voltage to ground: There should be about less than 1 V.
    • Blown No. 10 (7.5 A) fuse in the under-dash fuse/relay box
    • Faulty sunshade switch
    • An open in the wire