Registration for Immobilizer System
NOTE: The transmitter is automatically programmed to the vehicle when a transponder is programmed by HDS.
  1. Turn the ignition switch ON (II).
  1. Connect the HDS to the data link connector.
  1. Select IMMOBILIZER from the SYSTEM SELECT menu.
  1. Select the suitable menu from the HDS indications as follows.
    NOTE: The immobilizer-keyless control unit can store up to six transponders (transmitters).
    Added or replaced part
    Necessary operation after entering the Immobilizer Setup menu by the HDS
    Prepared part(s) when registered
    Information needed
    Replace any of the transmitters or keys
    Select ‘‘KEYS'', then ‘‘REWRITE KEYS''
    • All registered keys (transmitters)
    • All new keys (transmitters)
    ECM code
    Add transmitters or keys
    Select ‘‘Add and Delete Keys'', then ‘‘Delete or Add Multiple Keys''
    • All registered keys (transmitters)
    • All new keys (transmitters)
    HDS 1st password
    Deleting the registration of lost transmitters or keys
    Select ‘‘KEYS'', then ‘‘REWRITE KEYS''
    All new keys (transmitters)
    ECM code
    All keys (transmitters) are lost.
    Replace all keys (transmitters).
    Select ‘‘KEYS'', then ‘‘ALL KEYS LOST''
    All new keys (transmitters)
    ECM code
    The immobilizer-keyless control unit is replaced.
    Select ‘‘REPLACE IMMOBI UNIT''
    All registered keys (transmitters)
    ECM code
    ECM is replaced.
    Select ‘‘REPLACE ECM''
    All registered keys (transmitters)
    ECM code
    The steering lock assembly is replaced (also all transponder/keyless transmitters are replaced and registered).
    Select ‘‘KEYS'', then ‘‘ALL KEYS LOST''
    All new keys (transmitters)
    ECM code
    Replace MICU
    Select ‘‘Replace MPCS/MICU/IMOES''
    Under-dash fuse/relay box
    ECM code