Automatic Lighting/Rain Sensor Input Test
  1. Remove the cover (A) and the automatic lighting/rain sensor (B).
  1. Disconnect the 5P connector (C) from the automatic lighting/rain sensor.
  1. Inspect the connector and socket terminals to be sure they are all making good contact.
    • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
    • If the terminals look OK, go to Step 4 .
  1. With the connector still disconnected, make these input tests at the connector.
    • If any test indicates a problem, find and correct the cause, then recheck the system.
    • If all the input tests prove OK, replace the automatic lighting/rain sensor.
    Cavity
    Wire
    Test condition
    Test: Desired result
    Possible cause if result is not obtained
    1
    LT BLU
    Under all conditions
    Check for voltage to ground: There should be battery voltage.
    • Blown No. 17 (7.5 A) fuse in the under-hood fuse/relay box
    • An open in the wire
    2
    WHT
    Ignition switch ON (II)
    Check for voltage to ground: There should be battery voltage.
    • Blown No. 1 (7.5 A) fuse in the under-dash fuse/relay box
    • An open in the wire
    3
    BLK
    Under all conditions
    Check for continuity to ground: There should be continuity.
    • Poor ground (G501)
    • An open in the wire
    4
    BRN
    Under all conditions (Disconnect the combination light switch 12P connector)
    Check for continuity between the No. 4 terminal and No. 10 terminal of the combination light switch 12P connector: There should be continuity.
    An open in the wire
    5
    PNK
    Under all conditions (Disconnect the under-dash fuse/relay box connector Q (16P))
    Check for continuity between the No. 5 terminal and No. 6 terminal of the under-dash fuse/relay box connector Q (16P): There should be continuity.
    An open in the wire