Side Impact Sensor (First) Replacement
NOTE: Review the seat replacement procedure before doing repairs or service.
Removal
  1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
  1. Disconnect the floor wire harness 4P connector from the side impact sensor (first).
  1. Remove the cover (A) and using a TORX T30 bit, remove the TORX bolt (B), then remove the side impact sensor (first) (C).
Installation
  1. Install the new side impact sensor (first) with the TORX bolt (A), then connect the floor wire harness 4P connector (B) to the side impact sensor (first).
  1. Reinstall the cover (C).
  1. Reconnect the negative cable to the battery.
  1. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
  1. Reinstall all removed parts.