Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.

Disconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, both seat belt tensioner 4P connectors, and both seat belt outer lap tensioner 2P connector.

Remove the front inner fender.

Disconnect the engine compartment wire harness 2P connector (A), and using a TORX T30 bit, remove the TORX bolt (B) then remove the front impact sensor (C).

Install the new front impact sensor with a new TORX bolt (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).

Reconnect the negative cable to the battery.

After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.

Reinstall all removed parts.