Steering Wheel Installation
  1. Before installing the steering wheel, make sure the front wheels are aligned straight ahead, then center the cable reel (A). Do this by first rotating the cable reel clockwise until it stops. Then rotate it counterclockwise about three full turns. The arrow mark (B) on the cable reel label point should point straight up.
  1. Position the two tabs (A) of the turn signal cancelling sleeve (B) as shown. Install the steering wheel on to the steering column shaft, making sure the steering wheel hub (C) engages the pins (D) of the cable reel and tabs of the turn signal canceling sleeve. Do not tap on the steering wheel or steering column shaft when installing the steering wheel.
  1. Install the steering wheel bolt (A), and tighten it to the specified torque. Connect the cable reel subharness connector (B). Make sure the wire harness is routed and fastened properly.
  1. Reconnect the negative cable to the battery and do the following items:
    • Turn the ignition switch ON (II), the SRS indicator should come on for about 6 seconds and then go off.
    • Set the clock.
    • Verify cruise control, audio remote, navigation guide (if equipped) and turn signal canseling for proper operation.
    • Make sure the steering wheel is centered.